Coke Ovens
For more than 30 years, FIBS has been providing coke plants with technologies dedicated to the PREVENTIVE MAINTENANCE and CURATIVE REPAIR of the refractories of coke ovens, as well as a unique process for the REDUCTION OF AIR EMISSIONS (cross leakages). These technologies have been fully in house engineered.
Our Special Techniques to Reduce Stack Emissions
Ceramic Welding
Ceramic Welding process of FIBS has been developed in the early 90's. This process is now accepted by the industry as one of the most performing process thanks to :
A Simple and Easy Equipment
​
-
Less manpower
-
No electricity, no electronics, no nitrogen
-
No pressurized vessel
-
No complex regulation for material flow
-
Cleaning with Hammers / Sandblasting
A First Class Material
​
-
High Quality Raw Materials
-
Strong Quality Controls
-
Material adapted to all parts
-
Material for welding at low temperature
An Experienced Team
​
-
Deep knowledge of refractories
-
Long experience of coke oven
S-Bricks
The application of S-Bricks is a quick and cheap solution to the hot repair of major damages.
It can be applied for :
​
-
End Flue Repair (full height) : possible to repair 1st and 2nd flues even for tall ovens (lifetime > 4 years for 7 m tall battery)
-
Flues Repair (partial) after cleaning of the heating flue bottom
-
Flues Repair (partial) deeper in the coke oven chamber
Liquid Dusting for the Reduction of Air Emissions (Microcracks Treatment) : RPR SL
Air emissions and environmental care are to be considered as an important factor of the coke production.
Air emissions due to the coke production process have various origins, among them the cross leakages between the coking chamber and the heating flues. When the leakages are below 2 mm, it is very difficult to close them individually with ceramic welding. FIBS has engineered an genuine process that allows the global sealing of microcracks up to 2 mm.
​
The process consists in the pulverization of approximately 2 liters of liquid material (it is not a waterous suspension of silica) in the coke oven chamber. The material will ignite and create a cloud of new silica particles (amorphous = no risk for health) that will be pushed by the pressure release of the reaction through the cracks until complete sealing of the coking chamber. The application takes only 5 minutes
​
Main advantages
​
-
No risk for silica disease
-
Quick and easy
-
More efficient than silica dusting
-
No deposit on the flue bottom
Glass Coating (RPR GC)
RPR GC (Glass Coating) is a very specific grade of ceramic welding material especially developed to prevent a strong and deep anchorage of carbon in the refractory lining of the coke oven. This material can be applied in :
​
-
The charging hole area
-
The Upper part of the chamber
-
The ascension pipe and the goose neck
Endoscopy
FIBS has developed its own endosopic equipment in the prupose of assistance during the repairs in the middle of the ovens, or in the heating flue. This Equipment can also be used for the monitoring of heating flue, gas gun, regenerators, and channels.
Expertise, Technical Assistance and Training
FIBS has set up an expert team with long-experienced coke plant operators/managers, ceramic welding specialists and refractory specialists. This team is able to :
​​
-
Train and assist contractor (ceramic welding, best practice for maintenance, refractories, etc.)
-
Assist the coke pant with solving problem, implementation of a maintenance programm, adjustment of production parameters, etc...
-
Provide any other audit and survey service (conditions of the ovens, recommendations, etc.)
​
FIBS' specialists have already trained, certified and assisted more than 350 ceramic welders in more than 25 different countries !
​